These instructions show how to add an installed video doorbell to the customer App, when a WIFI connection needs to be made.
Go to this link for instructions and a demo video:
https://answers.alarm.com/PC/Property_Management_Support/Video/Alarm.com_Video_Doorbell_(ADC-VDB750)_Resident_Guide
- To verify your doorbell is ready to connect to Wi-Fi, press and hold the doorbell button for 45 seconds. Release when the LED light starts blinking red and green. Then, wait a few moments until the LED begins blinking white. This indicates the doorbell is ready to enroll. If the doorbell does not blink white, please contact your property manager for assistance.
- Open the PointCentral app.
- Tap Doorbell Camera.
- Tap Add Doorbell Camera.
- Tap to select ADC-VDB750.
- Verify the LED Light on the doorbell is flashing white, then tap Next.
- Add a preferred device name (e.g., Unit 102 Doorbell).
- Connect to the camera's Wi-Fi network. The network name format will be ADC-VDB750 (XX:YY:ZZ) where XX:YY:ZZ is the last 6 characters of the camera's MAC address. The camera's MAC address will be provided to you by your property manager.
- The doorbell should begin Installing. This may take a few minutes.
- Once installation is completed, the Video Doorbell is enrolled. Use the PointCentral app to select the chime type.
- Tap Doorbell Camera.
- Tap
- Using the Chime Type dropdown menu, tap to select the appropriate chime type.
- Tap "check"